WP-T810 Thermal Printer General Description 1.1 Overview The WP-T810 thermal line thermal receipt printer is designed for use with ECR, POS Terminal, electronic instruments, computer peripheral equipment, kitchen printer, and so on. 1.2 Feature 1 Compact desktop Line Thermal printer.
WP-T810 Thermal Printer 1.3 Accessories Item Unit Paper roll / 80mm (width) x 70mm (diameter) (1 roll) Power adapter (1 unit) Power cord (1 unit) User’s manual and driver CD (1 unit) Paper divider for 58mm (width) thermal paper (1 unit)
WP-T810 Thermal Printer 2.2 Operating Specifications Item Specifications 0 to 45℃(32 to 113℉),0 to 90% RH no Operating condensation allowed.(Refer to ambient Temperature/ operating ranges in the figure below.) Humidity -10 to +50℃(14 to 122℉),0 to 90% RH Storage:(shipped packed state) (excluding paper) 〔%RH〕...
WP-T810 Thermal Printer 4 Installations 4.1 How to Connect Power Adapter 1 Ensure that the power switch is OFF. 2 Plug the power connector into the printer’s power connector. 3 Plug the power cord into the outlet, and turn on the power.
WP-T810 Thermal Printer 4.2 How to Connect Cash Drawer 1 Ensure that the power switch is OFF. 2 Plug the connector into the RJ11 phone jack. 3 Note: The voltage for drawer kick out is 24VDC. If voltage of cash...
WP-T810 Thermal Printer 4.4 How to Load Thermal Paper 1 Pull the cover open lever to open the printer cover. 2 Remove any used paper roll’s core and put the new paper roll.
Page 16
WP-T810 Thermal Printer 3 Pull out the thermal paper. 4 Close the printer cover.
WP-T810 Thermal Printer 5 Control Panel 5.1 Basic Operation 1 Feed button When this push-button switch is pressed once briefly (for 0.5 seconds or less), the paper is fed forward by one line. When it is held down continuously, the paper is fed forward continuously until the switch is released.
Page 18
WP-T810 Thermal Printer 3 Paper LED indicator The indicator remains lighting when paper near end or paper end. The indicator keeps sparkling when printer process in self-test or hexadecimal dump mode. The flash timing chart shows as below. Printer status...
WP-T810 Thermal Printer 5.2 Switch Operation (Combined Switch Operation) 1 Self-printing mode Turn the power on while holding the feed button depressed. Self-printing receipt will be printed out (Ref. the right receipt). Self-printing will be performed according to VER. NO.,...
Page 20
WP-T810 Thermal Printer 2 Hexadecimal dump mode Open printer cover. Turn on power while holding the feed button depressed. Then close printer cover. The printer will be set to hexadecimal mode. Each of the signals sent from the computer to the printer will be printed out in hexadecimal code.
WP-T810 Thermal Printer 5.3 Setting Use screw driver to unlock the DIP switch cover from the printer bottom. The dip-switch appearance is as below and can be adjusted. 1 Select handshaking control SW1-3 Handshaking control DTR/DSR XON/XOFF 2 Select parity check...
Page 22
WP-T810 Thermal Printer 3 Select parity type SW1-6 Parity type Even 4 Select baud rate SW1-7 SW1-8 Baud rate 9600 bps 19200 bps 38400 bps 115200 bps 5 Select handshaking busy condition SW2-1 Handshaking busy condition Off line and receive buffer full...
Page 23
WP-T810 Thermal Printer 8 Select error beep alarm SW2-6 Error beep alarm Silence Alarm 9 Select paper width SW2-7 Paper width 80 mm 58 mm 10 Select page print mode SW2-8 Page print mode Disable Enable...
WP-T810 Thermal Printer 6 Interface Specifications WP-T810 has built-in USB and also provides RS232c, centronics, Ethernet and other interface cards, which is replaceable for more convenient adjustment according to requirement. 6.1 Changing the Interface Card Turn off the printer and all components connected, remove the 2 screws and the interface card unit.
WP-T810 Thermal Printer 6.2 Serial Interface Specifications 1 Specifications (Conform to RS-232C) Synchronizing system Asynchronous system Handshaking DTR/DSR control Baud rate 9600,19200,38400,115200 (Refer chapter 5-3) Data length 7 or 8 bit length Parity None, even or odd 2 Pin assignment...
WP-T810 Thermal Printer 6.3 Parallel interface specifications 1 Specifications (Conform to Centronics) Data transmission format 8-bit parallel Synchronizing system According to the strobe pulses Handshaking According to the BUSY signal Signal level TTL level 2 Pin assignment Signal Name Signal Name STB- F.G.
WP-T810 Thermal Printer 6.4 USB Interface Specifications 1 Specifications USB B type/ female USB specification 2.0 complaint, full speed mode (12 Mbps). 2 Pin assignment Signal Name Function 5VDC Power input USBD- USB data signal - USBD+ USB data signal +...
WP-T810 Thermal Printer 7 Cash Drawer Connector 1 Specifications Data Transfer System The pulse specified by “ESC p” is output to this connector. The host can confirm the status of the input signal by using the “ESC u” command. Electrical Characteristics...
WP-T810 Thermal Printer 8 Commands Command Code (Hex) Name Horizontal tab Command Code (Hex) Name Print and line feed Command DLE EOT n Code (Hex) Name Real-time status transmission Command DLE DC4 n m t Code (Hex) n m t...
Page 30
WP-T810 Thermal Printer Command ESC 2 Code (Hex) Name Select default line spacing Command ESC 3 n Code (Hex) Name Set line spacing Command ESC = n Code (Hex) Name Set peripheral device Command ESC ? n Code (Hex) Name...
Page 31
WP-T810 Thermal Printer Command ESC V n Code (Hex) Name Turn 90° clockwise rotation mode on/off Command ESC \ nL nH Code (Hex) 5C nL nH Name Set relative print position Command ESC a n Code (Hex) Name Select justification...
Page 32
WP-T810 Thermal Printer Command GS ! n Code (Hex) Name Select character size Command GS * x y d1..d(x*y*8) Code (Hex) Name Define downloaded bit image Command GS ( A pL pH n m Code (Hex) Name Execute test print...
Page 33
WP-T810 Thermal Printer Command GS a n Code (Hex) Name Enable/disable automatic status back(ASB) Command GS b n Code (Hex) Name Turns smoothing mode on/off Command GS f n Code (Hex) 66 n Name Select font for Human Readable Command...
Page 34
WP-T810 Thermal Printer Command FS . Code (Hex) Name Cancel Kanji character mode Command FS C n Code (Hex) 1C 43 n Name Select Kanji character code system Command FS S n1 n2 Code (Hex) n1 n2 Name Set left- and right-side Kanji character...
WP-T810 Thermal Printer 9 Character Code Tables 9.1 International Character sets ASCII (Hexadecimal notation) Country 23 24 40 5B 5C 5D 5E 60 7B 7C 7D 7E $ @ [ à ° ç § é ù è ¨ France §...
Need help?
Do you have a question about the WP-T810 and is the answer not in the manual?
Questions and answers