Nokia N9 Service Manual page 13

7) Unscrew the two Torx+ size 4 screws. Do not use
them again. Discard them.
9) Insert a flathead screwdriver in the shown hole on
the top side of the phone. Twist the screwdriver so
that the DISPLAY ASSEMBLY slightly rises out of the
PLASTIC BODY. Be careful not to damage the PLASTIC
BODY.
11) Slide the SRT-6 along the top side of the phone,
between the DISPLAY ASSEMBLY and the PLASTIC
BODY. Be careful not to damage the shown flex
located halfway the top side.
13
8) When releasing the DISPLAY ASSEMBLY be very
careful not to damage the highlighted parts of the
PLASTIC BODY with the screwdriver!
10) Insert a flathead screwdriver in the shown hole
and push it up to release the other side of the
DISPLAY ASSEMBLY. Be careful not to damage the
PLASTIC BODY.
12) Use the SRT-6 to open the left side of the DISPLAY
ASSEMBLY.
Conf idential | Copyright © 2011 Nokia | A ll rights reserved
Nokia N9 (RM-696)
L1L2 Service Manual
Version 5.0