Clearances Around Boiler; Check List - Baxi Combi Instant 80e User Operating Instructions Manual

5mm Min
Fig. 23
450mm Min
For Servicing
Purposes
5mm
In Operation
Fig. 24
10
450mm
5mm Min
200mm Min
200mm Min
4.0 Clearances and Check List
4.1 Clearances around the Boiler
(Figs. 23 & 24)
1. The minimum clear spaces needed around the boiler
measured from the casing are as follows:
Top -
Bottom -
Both sides -
Front -
-
2. These areas must not be obstructed in any way.
Blocking the clearance spaces may result in the boiler
overheating and damage may occur.
780mm
3. The gas burning compartment of your boiler is
completely sealed from the room in which it is fitted.
Products from the combustion of gas are vented to the
outside through the flue terminal which must be kept
free from obstruction as this would interfere with the
correct operation of the boiler.
4. The boiler may be installed in a cupboard if these
minimum clearances are kept. The compartment should
be large enough to house the boiler and ancillary
equipment only.
5. IT SHOULD NOT BE USED AS A STORAGE
CUPBOARD.
4.2

Check List

1. If a fault develops, or is suspected, call your installer or
Service Engineer as soon as possible.
2. Go through the following check list before you make
contact.
a) Is the electricity supply on ?
b) Is the selector switch on (giving a green
"Power ON" neon) and set for both Central
Heating and Domestic Hot Water ?
c) Is the red "Flame Failure" neon lit ?
Turn the On/Off/Reset selector fully anticlockwise.
d) Is the gas supply on ?
e) Is the mains water supply turned on ?
f) Is the system pressure correct ?
g) Are the boiler temperature controls set high
enough ?
h) Is the time clock (if fitted) calling for central
heating ?
i) Is the room thermostat (if fitted) set high enough ?
j) Are the radiator valves open ?
200mm
200mm
5mm
5mm (In Operation)
450mm (For Servicing)