Mounting The Protector - Makita RBC25A Instruction Manual

ASSEMBLY INSTRUCTIONS
Mounting the handle
(Fig.
1)
1 .
Attach the handle to the drive
shaft.
2.
Install the handle joint on the handle
as
shown
in
Fig.
1.
3.
Insert the installation bolt M6x45 through the
holes
in
the handle, and attach the flange nut M6.
4.
Adjust the handle to the
desired
position and
tighten the installation bolt.
Mounting the protector
(Fig. 2)
1.
Install the clamp on the drive shaft so that the
projection o f the clamp i s inserted into the
opening between the
gear case
and the
drive
shaft.
2. Attach the protector with two installation bolts
M6x20.
Mounting the nylon cutting head
1. Turn the machine upside down
so
that
you can
easily install the nylon cutting head.
2.
Insert the hex wrench through the hole in the
gear case, a n d turn the support washer until it is
locked
with the hex wrench (or the
shaft
is
locked).
3.
Using the socket wrench, remove the left-handed
nut (by turning it clockwise). Also remove the
tightening washer (Fig.
3).
4.
Screw the nylon cutting head onto the shaft
(Fig.
4).
IMPORTANT!
READ THE INSTRUCTIONS FOR U S E OF THE
NYLON CUTTING HEAD (PAGE
1 1 )
BEFORE
OPERATING THIS MACHINE.
Installation bolt
M6x45
\
Fig. 1
I
Gear case
I
Installation bolt M6x20
I
Protector
Fig. 2
Tightening
washer
Nut
Fig. 3
Hex wrench
7 7
Fig. 4
5
f