Summary of Contents for Pro-tec SYSTEM ONE PTS-2
- Page 1 PRO-TEC SYSTEM ONE Trailer Security Systems Model # PTS-2 Photo includes PTS-2 with optional pager unit “Professional Technology to Pro-Tec Your Investment”...
- Page 2 What it does The Pro-Tec System Two is designed to monitor and protect your trailer and its contents while at a race, job site, rest stop, hotel, restaurant, etc. This is accomplished by door switches and an accelerometer. Any acceleration of the trailer or opening of a door will trigger the alarm.
-
Page 3: Installation
Note: Wires must be kept away from the internal antenna. Control Box Outside Dimension: 5.12” Length 3.70” Width 2.24” Depth Installing alarm STEP ONE - Deciding on component locations SIREN 1. Keep it away from heat sources. 2. Point siren down so water does not collect in it. CONTROL UNIT 1. - Page 4 that door. 3. Connect 14 gauge wire from trailer running lights circuit to terminal block. NOTE: The control unit is able to handle up to 15 amp loads. 4. Connect 14 gauge wire from positive side of trailer brake to brake output terminal Note: The 12 Volt automotive battery must be grounded to trailer chassis.
- Page 5 3. Connect loose end of jumper wire to the “com” on the Output area of the terminal block. 4. Connect wire to the “N.O.” terminal located in the Output Section of the terminal block. This wire needs to be run to the Pro-Tec System control box and connected to the “Key Switch“...
- Page 6 KEYPAD OPERATIONS Entry/Exit Delay This is a programmable delay time that must be used to operate the interior keypad. In arming the alarm, the alarm will not be activated or the siren will not sound until after the preset delay from 0 to 35 seconds in 5-second increments has expired. The delay is programmed when the alarm is in the STANDBY MODE (the on-board led is not blinking).
- Page 7 PROGRAMING KEY FOBS PROGRAMMING THE KEYFOB AND RECEIVER Programming can either be done when the unit is first powered up or in the disarm status only. 1. To program the receiver to key-fob, momentarily short out the two program jumper pins on the circuit board. If done correctly, GREEN LED (D3) on the circuit board will flash at a rate of 300ms.
- Page 8 BEEP/FLASH JUMPER The arm/disarm annunciator may be changed from blink lights to a blinking lights and beep combination. In the STANDBY MODE, momentarily short the pins labeled BEEP/FLASH JUMPER. The lights will flash or the siren will beep to indicate the current mode. To change the mode, short the pins until the beep or flash indicator changes to the desired state.