Table of Contents
Advertisement
C
opyright
Copyright © 2009 by PLANET Technology Corp. All rights reserved. No part of this publication may be
reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer
language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or
otherwise, without the prior written permission of PLANET.
PLANET makes no representations or warranties, either expressed or implied, with respect to the contents
hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any
software described in this manual is sold or licensed "as is". Should the programs prove defective following
their purchase, the buyer (and not PLANET, its distributor, or its dealer) assumes the entire cost of all
necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the
software. Further, PLANET reserves the right to revise this publication and to make chang
in the contents hereof without obligation to notify any person of such revision or changes.
All brand and product names mention
trademarks of their respective holders.
F
ederal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off
the following measures:
1.
Reorient or relocate the receiving antenna.
2. Increase the
separation between the equipment and receiver.
3.
Con
nect the equipment into an outlet on a circuit different from that
is connected.
4.
Consult the dealer or an experienced radio technician for help.
F
CC Caution
To assure continued compliance. (example-use only shielded interface cables when connecting to computer or
peripheral devices). Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the Following two conditions: ( 1 )
T
his device may not cause harmful interference, and ( 2 ) th
in
cluding interference that may cause undesired operation.
Fede
ral Communication Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC radiation exposure set forth for an uncontrolled environment. In order to
avoid the possibility of exceeding the FCC radio frequency expos
shall not be less than 20 cm (8 inches) during normal operation.
Safe
ty
This equipment is designed with the utmost care for the safety of those who install and use it. However,
special attention must be paid to the dangers of electric shock and static electricity when working with
electrical equipment. All guidelines of this and o
times to ensure the safe use of the equipment
CE M
ark Warning
This is a Class B product. In a domestic environment, this p
case the user may be required to take adequate measures.
ed in this manual are trademarks and/or registered
and on, the user is encouraged to try to correct the interference by one or more of
to which the receiver
is Device must accept any interference received,
ure limits, human proximity to the antenna
f the computer manufacture must therefore be allowed at all
.
roduct may cause radio interference, in which
es from time to time
Advertisement
Table of Contents
