Makita 5740NB Instruction Manual page 12

1. Triangular rule
1. Limit mark
1
2
1. Brush holder cap
2. Screwdriver
ACCESSORIES
12
001508
1
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out
001518
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
CAUTION:
• These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding these
accessories, ask your local Makita service center.
• Carbide-tipped saw blades
Combination
Pressure treated/
Wet lumber
• Rip fence (Guide rule)
• Hex wrench 5
General purpose blade for fast and smooth rip,
crosscuts and miters.
Designed for fast cutting of pressure treated
and wet lumber.