Frigidaire CRA09EPT115 Use & Care Manual page 7

Installation Instructions
(continued)
Installation in a double=hung sash window
1. Cut the foam seals(adhesive type) to the proper lengths and attach them
to the window and stool. (Fig. 10)
2. Open the window sash and place the window slider kit on the window stool
(Fig. 11), Attach the window slider kit to the window stool. Adjust the length
of the window slider kit according to the width of window. Screw down the
two screws on the window slider kit, See Fig,11, Cut the adjustable window
slider kit if the width of window is less than 67,5cm (Fig. 12),
3. Close the window sash securely against the window slider kit, (Fig. 13)
4. Drive two 12.7 mm screws to secure the window slider kit to the window
sash. (FIG. 13)
5. Secure the window slider kit to the window stool (FIG. 13):
A: For wooden windows: Use 19mm screws for securing.
13:For Vinyl=Clad windows: Use 12.7mm hex head cap screws for securing.
6. To secure lower sash in place, attach right angle sash lock with
12.7mm (1/2") screw as shown (FIG. 14).
Fig. 10
ow slider kit
NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad
windows, so you can use lock by window itself.
7. Cut the foam seal to an appropriate length and seal the open gap
between the top window sash and outer window sash, as shown in Fig.!5.
rews ]
dow slider kit :_'_:_ : : ,ig. I,
Window stool g,
Window stool
Fig. 11
Cut this side to fit your window
i _" j % -)
Fig. 12
Installation in a sliding sash window
1. Cut the foam seals(adhesive type) to the proper lengths and attach them
to the window frame. See Fig.16.
2. Open the window sash and place the window slider kit on the window stool.
See Fig.17. Attach the window slider kit to the window stool. Adjust the
length of the window slider kit according to the height of window. Screw
down the two screws on the window slider kit. See Fig.17. Cut the adjustable
window slider kit if the height of window is less than 67.5cm (Fig. 12).
3. Close the sliding sash securely against the window slider kit. (Fig. 18)
4. Drive two 12.7mm screws to secure the window slider kit to the window sash.
(Fig. 18)
5. Drive two 19ram screws to secure the window slider kit to the window stool.
(Fig. 18)
6. Cut the foam seal to an appropriate length and seal the open gap
between the sliding sash and outer window sash, as shown in Fig.19.
7. To secure the sliding sash in place, attach right angle sash lock with 12.7mm
(1/2") screw as shown.(Fig.20)
Fig. 16
Windowstool Window slider kit
Fig. 17
Windowstool Window slider kit
Foam.
Fig. 19 Fig. 20 Fig. 18
©2009 Electrolux Home Products, Inc. All rights reserved. .--_
/