Advertisement
Available languages
Available languages
Sideburner
[] Loosen side burner in side shelf. (B). To loosen, unscrew and remove two front screws
holding sideburner in place. (A). Note: Do not loosen electrode screw.
[] Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
[] Insert valve stem through hole in fascia. (D) Attach bezel to fascia and valve face with
previously removed 2 screws. Attach bezel with black mark facing up (E).
[] Place sideburner tube over the valve, making sure that valve is inside sideburner tube. (F)
[] Pushcontrol knob onto sideburner valve stem. (G)
[] Reattach sideburner to sideburner shelf with the 2 previously removed screws. Replace
sideburner grate. (H)
[] Connect both igniter wires to the igniter module on the inside of the right fascia. To
connect, push igniter wire tips onto pins in igniter module. (I)
[] Unscrew igniter cap from control panel. Insert (1) AAA battery (provided in blister pack)
into battery slot with positive end (+) facing outward. Screw igniter cap back onto panel. (J)
26 • 34461-41600070
Advertisement
