Husqvarna 917.38451B Owner's Manual page 12

Rotary lawn mower
Hide thumbs Also See for 917.38451B:
Table of Contents

Advertisement

Available languages

Available languages

The
operat
on ofanY
awn
mowercan
resut
n fore0n
ob,
ects Use
ear
thrown into the eyes, which can result in severe eye damage,
protec-
Always wear safety glasses or eye shields while operating your
tors
to
lawn mower or performing any adjustments or repairs. We recom-
a v o i d
mend standard safety glasses or a wide vision safety mask over spectacles, damage to hearing.
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED
Engine speed was set at the factory for
optimum performance.
It is not adjustable.
ENGINE ZONE CONTROL
,ACAUTION:
Federal regulations
require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under
any circumstances
attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST
CUTTING
HEIGHT
Raise wheels for low cut and lower wheels
for high cut, adjust cutting height to suit
your requirements.
Medium position is
best for most lawns.
To change cutting height, squeeze ad-
juster lever toward wheel. Move wheel
up or down to suit your requirements.
Be sure all wheels are in the same set-
ting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position
adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
LEVER BACKWARD
TO LOWER MOWER
Plate tab
LEVER FORWARD TO RAISE MOWER
Lever
TO CONVERT
MOWER
Your lawn mower was shipped ready to be
used as a mulcher.
To convert to bagging
or discharging:
REAR BAGGING
• Lift rear door of the lawn mower and
place the grass catcher frame hooks
onto the door pivot pins.
• To convert to mulching or discharging
operation,
remove grass catcher and
close rear door.
Pivot pins
Rear
G rass
catcher
handle
Catcher frame hook
SI
o
o
DE DISCHARGING
Rear door must be closed.
Open mulcher door and install dis-
charge deflector under door as shown.
Mower is now ready for discharging
operation.
To convert to mulching or bagging
operation,
discharge deflector
must be
removed and mulcher door must be
closed.
/
Open mulcher door
Install
discharge
deflector
MOWER IS NOW READY FOR
DISCHARGING
OPERATION

Advertisement

Table of Contents
loading

Table of Contents