Advertisement
Quick Links
INSTALLATION
AND SERVICE
MUST
BE PERFORMED
BY
A QUALIFIED
INSTALLER.
IMPORTANT:
SAVE
FOR LOCAL
ELECTRICAL
INSPECTOR'S
USE.
READ
AND SAVE
THESE
INSTRUCTIONS
FOR FUTURE
REFERENCE.
This
conversion
kit must
be installed
by a qualified
service
technician
in accordance
with the manufacturer's
instructions
and all applicable
codes
and requirements
of the authority
having
jurisdiction.
Failure
to follow
instructions
may result
in fire, explosion
or production
of carbon
monoxide
causing
property
damage,
personal
injury or loss of life.
The qualified
service
agency
is
responsible
for the proper
installation
of this kit.
The installation
is not proper
and complete
until
the
operation
of the converted
appliance
is checked
as specified
in the manufacturer's
instructions
supplied
with this
kit.
[F_
Before
proceeding
with
the conversion,
shut
off the gas supply
before
disconnecting
electrical
power
to the range.
Be sure
both
power supplies
are off before
installing
the conversion
kit.
Failure
to do so could
cause
serious
bodily
injury.
When burners
are converted
from Natural to LP the BTU rating is as follows:
9,000 BTU* Natural Gas to 8,000 BTU* LP Gas. The LP converstion
kit contains:
P/N
Part Description
Notes
4
316470401
1
316417511
8,000* BTU LP Burner Orifices
LP Conversion
Installation
Instructions
marked
68L (.79mm
orifice size)
*NOTE;
For operation
at elevations
above 2000
ft.; appliance
rating
shall
be reduced
at the rate of 4 peicent
for each 1000 if, above
sea level. After
replacing
the natural
gas to LP orifices,
be sure to keep
the original
factory
installed
natural
gas orifices
for future
range
conversion
back
to natural
gas:
Converting
the appliance
for use with LP/
Propane
Gas
Tools
Required"
1/2" Open End Wrench
5/8" Open End Wrench
1/4" Nutdriver
10mm Nutdriver
10mm Open End Wrench
or
1. Convert
Pressure
Regulator
Before proceeding
with the conversion,
shut off the gas supply before disconnecting
electrical
power to the range.
Be sure both power supplies
are
off before installing the conversion
kit. Failure to do
so could cause serious
bodily injury.
a.
Lift and lock cooktop into raised position. Locate the gas
pressure regulator, The regulator is located atthe right rear
of the burner box and is attached to the manifold pipe.
b.
Unsnap the plastic dust cap protector from the brass
pressure regulator cap. Use a 5/8" open-end wrench to
loosen and then remove the brass pressure regulator cap
(See Fig. 1). DO NOT remove
the spring
from the
pressure regulator.
pin 316417511 (En/Fr) 0609
c.
Turn the pressure regulator cap over so the hollow end
faces toward the regulator as illustrated (See Fig. 1).
Before installing the brass pressure regulator cap, be sure
to remove the dust protector and reinstall the ring portion
of the dust protector. The ring portion of the protector
MUST be installed. The ring portion of the dust protector
acts as
a spacer between the regulator
and brass
regulator cap when converted to LP.
d:
Using a 5/8" open-end
wrench tighten the pressure
regulator cap until snug.
e:
Snap the dust protector back over the pressure regulator
cap.
HOLLOW END
PRESSURE
REGULATOR
CAP
TOWARDS
_
_
REGULATOR
_
FOR NATURAL
GAS _"
SOLID END
TOWARDS
REGULATOR
FORLP.
GAS
SPRING
Fig. 1
Advertisement
