Table of Contents
Advertisement
Connecting Jet Nozzle:
1) Insert jet nozzle to steam nozzle and align tabs.
2) Rotate jet nozzle clockwise until it locks into place with the steam nozzle.
1
Connecting Utility Brush(s)/Wide Nozzle Head:
3) Begin by aligning hexagonal shaped hole on back of the utility brush with hexagonal
tip of the jet nozzle and press firmly.
IMPORTANT: Make sure the accessory is pushed as far as possible onto tip to ensure
the fit is sealed. This will prevent steam from seeping out unwanted areas and prevent
injury.
4) To remove utility brush, make sure the unit is unplugged and has cooled down.
Firmly pull on brush until it detaches itself from the nozzle head.
Connecting Squeegee:
5) Connect the squeegee to the wide nozzle head by snapping the tabs located at the
bottom of the squeegee with the bottom of the wide steam nozzle head.
6) Connect the wide nozzle to the jet nozzle.
ASSEMBLY AND USE
3
5
4
2
6
Advertisement
Table of Contents
