Frigidaire FFRA0522Q14 Use & Care Manual page 10

Table of Contents

Advertisement

.....
i!i_i_:_ii_i!i!i!i!ii_!!_i!i!
i!i!!
!! i_i _il I i ! ii i _!_!
_!_!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_! _!_!_!
_!_!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_! _!_!_!
_!_!_!_
!_!
_! _!_!
_!_!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_! _!_!_!
_! _!_!_
!_!
_! _!_!
_!_!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_! _!_!_!
_! _!_!_
!_!
_! _!_!
_!_!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_!
_!_!_!
_! _!_!_
!_!
_! _!_!
_!_!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_!
_!_!_!
_! _!_!_
!_! _!_!_!
_!_!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_! _!_!_!
_!_!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_! _!_!_!
_!_!_!_
!_!
_! _!_!
_!_!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_! _!_!_!
_! _!_!_
!_!
_! _!_!
_!_!_!_
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!_
!_! _!_!_!
_! _!_!_
!_!
_! _!_!
_!_!_!
!_!
_! _!_!
_! _!_!_
!_!
_! _!_!
_! _!_!
i_i _i
Before
calling
for service,
review
this list, It may save you time and expense
This list includes
common
occurrences
that are not
the result of defective
workmanship
or materials
in this appliance
OCCURRENCE
SOLUTION
Air conditioner
will not operate.
Airfmm
unitdoesnotfeelcold
enough,
Wall
plug
disconnected.
Push plug
firmly
into wall outlet.
Plug Current
Device
Tripped.
Press the
RESET
button.
House
fuse
blown
or circuit
breaker
tripped.
Replace
fuse
with time
delay
type
or reset circuit
breaker.
Control
is OFF. Turn
Control
ON and set to desired
setting.
Room
temperature
betow
60°F
(16°C).
Cooling
may
not occur
until
room
temperature
rises
above
60%
(16°C).
Temperature
sensing
etement
touching
cold
coil, located
behind
air filter.
Straighten
away
from
coil.
Reset to a lower
temperature.
Compressor
shut-off
by changing
modes.
Wait
approximately
3 minutes
and
listen
for compressor
to
restart
when
set in the
COOL mode.
Air conditioner
cooling,
but room
is too warm
= ice forming
on cooling coil behind
decorative
front
Outdoor temperature betow 60 °F (16 °C). To defrost the coil, set FAN ONLY mode.
Air filter
may
be dirty.
Clean
filter.
Refer
to Care
and
Cleaning
section.
To defrost,
set to FAN ONLY
mode.
Temperature
is set too
Low for
night-time
cooling.
To defrost
the
coil, set to FAN ONLY mode.
Then,
set temperature
to a higher
setting.
Air conditioner
cooling,
but room
is too warm
- NO ice forming
on
cooling coil behind
decorative
front.
Dirty air filter - air restricted. Clean air filter. Refer to Care and Cleaning section.
Temperature is set too high. Set temperature to a lower setting.
Air directional louvers positioned improperly.
Position louvers for better air distribution.
Front of unit is blocked by drapes, blinds, furniture, etc. - restricts air distribution. Clear blockage in
front of unit.
Doors, windows, registers, etc. open - cool air escapes. Cbse doors, windows, registers, etc.
Unit recently turned on in hot room. Allow additional time to remove "stored heat" from wails, ceiling,
floor and furniture.
Air conditioner
turns
on and off
rapidly,
Dirty air filter - air restricted. Clean air filter.
Outside temperature extremely hot. Set FAN speed to a faster setting to bring air through cooling coils
more frequently.
Noise when
unit
is cooling,
Air movement sound. This is normal. If too loud, set to lower FAN setting.
Window vibration - poor installation. Refer to installation instructions or check with installer.
Water
dripping
INSIDE
when
Improper installationl Tilt air conditioner slightly to the outside to allow water drainage. Refer to
unit is cooling,
installation instructions or check with installer.
Water
dripping
OUTSIDE
when
Unit removing large quantity of moisture from humid room. This is normal during excessively humid
unit
is cooling,
days.
Room
too cold,
Set temperature too low. Increase set temperature.
If These Solutions
Fail, Call 1-800-944-9044
For Frigidaire
Service,

Advertisement

Table of Contents
loading

Table of Contents