Advertisement
Available languages
Available languages
Clear water
lines
12.
Secure
drain hose
Standpipe
Wall
Run water for a few seconds through hoses into a laundry tub,
drainpipe, or bucket to prevent clogs. Water should run until clear.
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with beaded tie strap.
O. Connect
inlet hoses to washer
Attach hot water hose to hot water inlet valve marked with a
red ring. Screw coupling by hand until it is snug. Use pliers to
tighten couplings an additional two-thirds
turn. Repeat with
cold water inlet valve.
IMPORTANT:
To reduce risk of hose failure, replace the hoses
every 5 years. Record hose installation or replacement
dates
for future reference.
• Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
1.
Check for leaks
C
LEVEL WASHER
IMPORTANT:
Level washer properly to reduce excess noise
and vibration.
Place level here
i
Move the washer to its final location. Place a level on top
edges of washer. Use side seam as a guide to check levelness
of sides. Check levelness of front using lid, as shown. Rock
washer back and forth to make sure all four feet make solid
contact with floor. If washer is level, skip to step 15, (on
models with metal feet) or step 16 (on models with plastic
feet).
Not Level
LEVEL
Not Level
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
Advertisement
