GE PDT760SIF1II Installation Instructions Manual

Installation Instructions
Built-in Dishwasher
If you have questions, call 800.GE.CARES (800.432.2737)or visit our Website at: GEAppliances.com.
In Canada, please call i.800.56E.3344 or visit www.geappliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING:
, To reduce the risk of electric shock, fire, or injury to
persons, the installer must ensure that the dishwasher is
completely enclosed at the time of installation.
FORPERSONAL SAFETY:Remove house fuse or open
circuit breaker before beginning installation. Do not use an
extension cord or adapter plug with this appliance.
The improper connection of the equipment grounding
conductor can result in a risk of electric shock. Check with
a qualified electrician or service representative if you are
in doubt that the appliance is properly grounded.
If house wiring is not 2-wire with ground, a ground
must be provided by the installer. When house wiring
is aluminum, be sure to use UL-Listed anti-oxidant
compound and aluminum-to-copper connectors.
When reinstalling the floor protect pan, make certain that
the screws have been fully secured. This will ensure that
if the unit is properly grounded, that the floor protect pan
will also be grounded.
CAUTION:
Do not remove wood base until you are ready to install the
dishwasher. The dishwasher will tip over when the door is
opened if base is removed.
FOR YOUR SAFETY
Read and observe all WARNINGS and CAUTIONS shown
throughout these instructions. While performing installations
described in this booklet, gloves, safety glasses or goggles
should be worn.
IMPORTANT -Observe all
governing
codes and
ordinances.
, Note to Installer - Be sure to leave these instructions for the
consumer's and local inspector's use.
Note to Consumer - Keep these instructions with your
Owner's Manual for future reference.
Skill Level - Installation of this dishwasher requires
basic mechanical, electrical and plumbing skills. Proper
installation is the responsibility of the installer. Product
failure due to improper installation is not covered under
the GE Appliance Warranty. See warranty information.
Completion Time - :1to 3 Hours. New installations require
more time than replacement installations.
IM PORTANT - The d ishwasher MUST be installed to
allow for future removal from the enclosure if service is required.
Careshould be exercisedwhen the appliance is installed or removed,
to reduce the likelihood of damage to the power supply cord.
If you received a damaged dishwasher, you should immediately
contact your dealer or builder.
Optional Accessories - See the Owner's Manual for available
custom panel kits.
Printed in the United States
CHECK THE FOLLOWING
,Tub trim does not interfere with the door
, Dishwasher is square and level at both the top and bottom
of the cabinet opening, with no twisting or distortion of the
tub or door
All 4 legs of the dishwasher are firmly in contact with the
floor
Drain hose is not pinched between the dishwasher and
adjacent cabinets or walls
Tub trim is fully seated on the tub flange
READ CAREFULLY
KEEP THESE INSTRUCTIONS
31-31546
09-14 GE