Installation - Frigidaire FFFU21M1QWA Use & Care Manual

PROBLFH CAUSE CORRECTION
Temperature ' Control iS set too warml o Set fresh food controlto a colder setting. Allow
inside, appli-several hours for temperature to stabilize:
t%_o¢_laSrm , Door is opened tOOfrequently
, Warm air entering the appliance causes it to
' I or too ong run more Open door ess often
D_r may not be _ating properly. - See"DOOR PROBLEMS, section
, Large amounts of warm , Warm food will cause appliance to run more
or hot food has been until the desired temperature is reached.
stored recently,
, Appliance has recently been , Appliance requires 4 hours to coo!
disconnected for a Ped0d. down completely,
of Lime.
Ex_ernaltem- • The external walls can be as • This is normal while the compressor works to
perat_re is much as 30OF warmer than transfer heat from inside the cabinet.
toe warm. room temperature.
SOUND AND NOISE
Louder sound • Modern appliances have • This is normal. When the surrounding noise is
levels when increased storage capacity low, you might hear the compressor running
applianoe is on. and more stable while it cools the interior.
temperatures. They require a
high efficiency compressor.
Longer sound ® Appliance operates at higher .,This is normal. Sound will level off or
levels when pressures during the start of disappear as appliance continues to run.
compressor the ON cyc!e.
Comes On. "
• Metal parts undergo * This is normal. Sound will level off or
expansion and contraction, as disappear as the appliance continues to run.
in hot water pipes.
, Refrigerant (used to cool ,, This is norma L
the appliance)is circulating
throughout the system,
Popping or
cracking sound
when compres-
sor
¢Om_ On.
Bubbling
or gurgling
sound, like
water boiling,
Vibrating or
rattling noise.
* Appliance is not level. It rocks
on the floor when it is
moved slightly.
. Floor is uneven or weak.
Appliance rocks on floor when
it is moved slightly.
. Appliance is touching the wall.
Thealarm • Look 0n _he control panel to
is sounding determine which indicator
* Level the unit. Refer to "Leveling" in the
INSTALLATION Section.
* Ensure floor can adequately support the
appliance. Level the appliance by putting wood
or metal shims under part of the appliance.
. Re-level or move the appliance slightly. Refer
to "Leveling" in the INSTALLATION Section.
, Press the "set" button to acknowledge the
alarm or close the door if the door ajar
from the con- light is on (High Temp, Power indicator is shown.
trol panel Fail, 0r Door Ajar) _ .................
WATER/HOISTURE/FROST INSIDE APPLIANCE
Moisture forms ® Weather is hot and humid. ' The rate Of frost buildup and internal
on inside I sweating increases. This is normal:
walls, * Door may not be * see "DOOR PROBLEMS"
seating properly.
, Door is opened too often or , Open door less often.
too long.