GE JB250 Owner's Manual page 23

30" range
Hide thumbs Also See for JB250:
Table of Contents

Advertisement

Available languages

Available languages

Troubleshooting
tips (Cont.) ... Before you call for service
Oven light does not work
Oven will not self=clean
Excessive smoking
during clean cycle
Excessive smoking
during broiling
Oven door will not open
after a clean cycle
Possible
Cause
Light bulb is loose or defective.
Pad operating light is broken.
The temperature
is too high to set a
self-clean
operation.
Oven controls improperly set.
Excessive soil or grease.
Food too close to burner element.
Oven too hot.
What
To Do
Tighten or replace bulb.
Call for service.
Allow the oven to cool and reset the controls.
See the Cleaning the Oven section.
Press the Cancel/Off pad. Open the windows to rid the
room of smoke. Wait until the LOCKED light goes off.
Wipe up the excess soil and reset the clean cycle.
Lower the rack position of the food.
Allow the oven to cool below locking temperature.
Oven not clean after a
, Oven controls improperly set.
_ See the Cleaning the Oven section.
Oven was heavily soiled.
Clean up heavy spitlovers before starting the clean
clean cycle
|
I
"LOCK DOOR" flashes
in
the display
DOOR LOCK light is on
when you want to cook
F-- and a number
or letter" flash in the
|
Display goes blank
The self=clean cycle has been
selected but the door is not closed.
The oven door is locked because
the temperature
inside the oven
has not dropped below the locking
temperature.
You have a function
error code.
If the function
code repeats.
A fuse in your home may be blown
or the circuit breaker tripped.
The clock is turned off.
Oven is in Sabbath Mode.
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
Close the oven door.
Press the Cancel/Off pad. Allow the oven to cool.
Press the Cancel/Off pad. Allow the oven to cool for
one hour. Put the oven back into operation.
Disconnect att power to the oven for at least 30
seconds and then reconnect power. If the function error
code repeats, call for service.
Replace the fuse or reset the circuit breaker.
See the Special features section.
Verify that the oven is not in Sabbath Mode. See the
Special Features section.
Power outage, clock
flashes
"Burning"
or "oily"
odor
emitting from the vent
Strong odor
This is normal in a new oven and
will disappear in time.
An odor from the insulation around
the inside of the oven is normal for
the first few times the oven is used.
m
Power outage or surge
Reset the clock. If the oven was in use, you must reset
it by pressing the Cancel/Off
pad, setting the clock and
resetting any cooking function.
To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Cleaning the Oven section.
This is temporary and will go away after several uses
or a self-clean cycle.
L
My oven door glass
No. The inner oven glass is coated
This is normal. Under certain bightor angles, you may
appears to be "tinted"
or
with a heat barrier to reflect the
see this tint or rainbow color.
have a "rainbow"
color,
heat back into the oven to prevent
Is this defective?
heat loss and keep the outer door
cool while baking.
©
C
t==.
r_
I
©
©
u
Z
©
m
49 8 07002
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Js250Jds28Jb350Jss28

Table of Contents