Dishwasher Feedback Section; Cancelling A Cycle; Dishwasher Features; Adding A Dish After Dishwasher Is Started - Jenn-Air JDB8500AWX3 User Instructions

/_ _!i:_ JW_!!_!i_ _!_j I::_!!_iiiiiii_!!i_ii_i_ _!!ii_!!_i_ili_ii_i i
CONTROL PURPOSE COMMENTS
The Cycle Status Indicator Clean indicator glows when a cycle is finished.
Lights are used to follow the If you select the Sanitize option, when the Sanitize cycle is finished, the
progress of tne aJsnwasner Sanitized indicator glows. If your dishwasher did not properly sanitize your
cycle. Located on the front dishes, the light flashes at the end of the cycle. This can happen if the
of the dishwasher for front cycle is interrL pted, or the water could not be heated to the required
control models, and located temperature.
on the top of the door for
hidden control models. The Clean and Sanitized lights go off when you open and close the door or
press CANCEL.
A
The Front Indicator Light or
Single Exterior Light (A)
shows progress of your
dishwasher cycle by color
(for non-Pro handle hidden
control models only).
The light will be blue if the dishwasher is washing or rinsing. The light will
be red when the dishwasher is drying. The light will be green to indicate
that the cycle is complete. If the Front Indicator Light is blinking, see
"Troubleshooting" section.
Canceling A Cycle
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop before completely opening the door.
2. Press the Cancel/Drain button once. The Cancel/Drain light
will light up.
3. Close the door and the dishwasher starts a drain cycle (if water
remains in bottom of dishwasher). Let the dishwasher drain
completely. The Cancel/Drain light turns off after 2 minutes.
Changing A Cycle After Dishwasher Is Started
1. You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure.
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3. Check that detergent dispenser cover is still closed. If cover is
open, you will need to refill the detergent dispenser before
restarting your new cycle.
4. Press CANCEL/DRAIN twice to reset the control.
5. Select new cycles and options.
6. Press START/RESUME.
Adding A Dish After Dishwasher Is Started
1. Check if Add a Dish indicator is lit. (Available on some models.
Otherwise, proceed to Step 2.)
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3. Check whether the detergent dispenser cover is still closed. If
it is open, the wash cycle has already started and adding a
dish is not recommended.
4. If detergent has not yet been used (detergent dispenser cover
is closed), you may add a dish.
5. Press START/RESUME.
Your Jenn-Air _ dishwasher may have some or all of these features.
Silverware Basket
Use the slots in the
covers to keep your
silverware separated for
optimum wash. There
are specially designed
slots (small round holes)
for chopsticks. Mix silverware types to keep them separated. Load
knives down, forks up, and alternate spoons, for best cleaning
results.
NOTE: If your silverware does not fit into the designated slots, flip
the covers up and push them down into the basket.
Cup and Stemware Holder (on some models)
Fold down the extra shelf on the left-hand or right-hand side of the
mid level rack to hold additional cups, stemware or long items such
as utensils and spatulas.
NOTE: Remove the culinary tool basket(s) when washing tall
stemware or other tall items in the top rack.
11