Page 1
REQUIRES REQUIRES CONTENTS SPECIFICATIONS SPECIFICA C C TIONS Proto-X SLT Nano Quadcopter pter Size: 1.97" [50mm] (distance between diagonal motors) Siz i i e: 1.97" [50mm] (distance between diagonal motors) Four AAA 1.5V alkaline batteries Four AAA 1.5V alkaline batteries USB Charge Cord Flying Weight: 0.4 oz [11.1 g]...
Page 2
15th regulation of FCC. This limitation requires reasonable • Your Proto-X SLT quadcopter should not be considered a toy, but rather a anti-interference protection around the residence. The device can transmit small, working model. If not operated correctly, the model could possibly radio wave during use and can interrupt the mobile communication without cause injury to you or spectators and damage to property.
Page 3
If the winds are calm, battery and unplug the charger immediately if either becomes hot! experienced pilots may also be able to fly the Proto-X SLT outdoors. However, it is normal for the charger to get warm.
Page 4
ROTATE RIGHT POWER-ON (FAIL-SAFE) PROCEDURE Your Proto-X SLT Nano Quadcopter is fitted with a Power-On fail-safe. This is designed to ensure that the motor will not start unless it detects a suitable radio-control signal when the LiPo battery is connected. The correct Start-Up...
Page 5
It is normal for the Proto-X SLT to drift slightly. However if it drifts in any direction consistently press the trim button opposite the movement as many Roll/Aileron Sensitivity: Push down on the times a needed to eliminate the drift.
Page 6
TROUBLESHOOTING 360° AERIAL FLIPS (Expert Mode Only) PROBLEM: The quadcopter will not respond to the controller. Tip: Perform the flip while gaining altitude. SOLUTION: (1) Charge or change the battery on the quadcopter (2) Make sure that the throttle is at 0% and the throttle trim at or below center. (3) Turn off the quadcopter for a minute and turn it back on.
Page 7
LINKING THE QUADCOPTER SLT SETUP AND CONTROLLER The Proto-X SLT Nano Quadcopter can be used with other SLT controllers. If your controller has programmable settings or if it uses an ANYLINK/ The Proto-X SLT uses Wavelink ™ technology to link it to the controller. If ANYLINK2 adapter, please use these settings as a guide to get started.
Need help?
Do you have a question about the Proto-X SLT and is the answer not in the manual?
Questions and answers