Glass Cooktop - GE JBS27RF1SS Owner's Manual

Cleaning the glass cooktop. Con some mode/s
Clean your cooktop after
each spill. Use CERAHA
BRYTE ®Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLYuse CERAMABRYTE ® Ceramic Cooktop
Cleaner on the glass cooktop. Other creams
may not be as effective.
To maintain and protect the surface of your
glass cooktop, follow these steps:
%
Before using the cooktop for the
first time, clean it with CERAMA BRYTE ®
Ceramic Cooktop Cleaner.This helps
protect the top and makes cleanup easier.
[] Daily use of CERAMABRYTE ® Ceramic
Cooktop Cleaner will help keep the
cooktop looking new.
r-_ Shakethe cleaning cream well. Apply a
few drops of CERAMABRYTE ® Ceramic
Cooktop Cleanerdirectly to the cooktop.
r_ use a paper towel or CERAIVlA BRYTE ®
Cleaning Pad for Ceramic Cooktops to
clean the entire cooktop surface.
Use a dry cloth or paper towel to
remove all cleaning residue. No need to
rinse.
NOTE: It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
Use a CERAMABRVTE ® Cleaning
Pad for Ceramic Cooktops.
Burned-On Residue
NOTE: DAMAGEto your glass surface may
occur if you use scrub pads other than those
recommended.
r_ Allow the cooktop to cool.
Spread a few drops of CERAiVlA BRYTE ®
Ceramic Cooktop Cleaner on the entire
burned residue area.
@
Using the included CERAMABRYTE ®
Cleaning Pad for Ceramic Cooktops, rub
the residue area, applying pressure as
needed.
%
@
If any residue remains, repeat the steps
listed above as needed.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE ®
Ceramic Cooktop Cleaner and a paper
towel.
The CERAMA BRVTE ® Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts
Center. See instructions under "To
Order Parts" section on next page.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
F71
A llow the cooktop to cool.
Use a single-edge razor blade scraper
at approximately a 45 ° angle against
the glass surface and scrape the soil. It
will be necessary to apply pressure to
the razor scraper in order to remove
the residue,
@
After scraping with the razor scraper,
spread a few drops of CERAMABRYTE ®
Ceramic Cooktop Cleaner on the entire
burned residue area. Use the CERAMA
BRYTE ® Cleaning Pad to remove any
remaining residue.
%
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE ®
Ceramic Cooktop Cleaner and a paper
towel.
26