Advertisement
Installation
ADDING
ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
, Insert the elbow through the rear opening and connect
it to the dryer internal duct.
,Apply duct tope on the joint between the dryer internal
duct and elbow, as shown above.
ADDING COVER PLATE TO REAR OF
CABINET
Connect standard metal elbows and ducts to complete
the exhaust system. Cover back opening with a plate
(Kit WEIM454) available from your local service provider.
Place dryer in final location.
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
PLATE
(KITWE1M454)
,iI_WARNING-NEVER
LEAVE THE
BACK OPENING WITHOUT
THE PLATE
{KIT WEIM454).
114]CHANGINGDIRECTIONOF DOOR OPENING
1. Open the door and remove the filler plugs opposite the
hinges. With the door completely open, remove the
bottom screw from each hinge on the dryer face. Insert
these screws about half way into the TOP holes, for each
hinge on the opposite side (where you removed the filler
plugs). Apply firm pressure to get the screws started.
REMOVE 4 PLUGS AND
KEEP
FOR INSERTION
INTO
THE OPPOSITE
SIDE
REMOVEBOTTOMSCREW FROMEACHHINGE
AND INSTALL HALF WAY INTO EACH TOP OF
2. Loosen the top screw from each hinge on the dryer face
halfway. With one hand holding the top of the door and
the other hand holding the bottom, remove the door
from the dryer by lifting it UP and OFF.
Instructions
LOOSEN EACH TOP HINGE
SCREW HALF WAY AND LIFT
THE DOOR UP AND OFF
3. Removethe blind plate from
the hinge side of the dryer
by removing its two screws.
Removethe strike plate from
the opposite side of the dryer
by removing its two screws, pLATE
Reinstall the plates, on the
opposite sides, using two
screws in each plate.
4. Rotate the door 1800. Insert the door on the opposite
side of the opening by moving the door ON and DOWN
until the top hinge and the bottom hinge are resting on
the top screws inserted in step 1.
ROTATE DOOR 180 ° AND HANG
TON TOP HINGE SCREWS
//
5. Remove the remaining screws from the side of the
opening from which the door was removed. With these
screws secure each hinge at the bottom. Tighten the
two top screws on each hinge. Reinsert the plastic plugs
on the side from which the door was removed.
INSTALLANDTIGHTEN
BOTTOM
INSERT PLUGS
SCREWS AND TIGHTEN TOP
INTO HOLES ON
_._OPPOSITE
SIDE
SERVICI N G
WARN !N
G-LABEL ALL WIRES PRIOR
TO DISCONNECTING
WHEN
SERVICING
CONTROLS. WIRING ERRORS CAN CAUSE
IMPROPER AND DANGEROUS OPERATION
AFTER SERVICI NG/I NSTALLATION.
8
REGISTERYOUR NEW APPLIANCE TO RECEIVE
ANY IMPORTANT PRODUCT NOTIFICATIONS.
Please go to www.GEAppliunces.com
or mail in
your product registration
card.
For questions on installation, call: 800.626.2000 (US)or
800-561-3344 (Canada).
Advertisement
