Plate To Wall - GE AVM4160 Installation Instructions Manual

Installation Instructions
I-B-IOUTSIDE TOP EXHAUST
{Vertical Duct)
INSTALLATION OVERVIEW
B1. Attach Mounting Plate to Wall
B2. Prepare Top Cabinet
B3. Adjust Blower Motor
B4. Install Exhaust Adaptor
BS. Mount Microwave Oven
B6. Adjust Exhaust Adaptor
B7. Connect Ductwork
I
i
I I
I I
| ATTACH THE MOUNTING PLATE
TO THE WALL
A
\
C" D
Attach the plate to the wall using toggle bolts, At least
one wood screw must be used to attach the plate to
a wall stud, Recommended locations on the mounting
plate are indicated by A, B, C and D,
_!_ Remove the toggle wings from the bolts,
[]Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to ¾" onto each bolt,
16
To use toggle bolts:
Spacing for Toggles More
÷l_"-_i_---Than Wall Thickness
I
Mounting ]Toggle Wings
Plate.
Mounting Plate Bolt End
[] Insert the toggle wings into the holes in the wall and
place the mounting plate against the wall,
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the
wall and that the plate is properly centered under the
cabinet,
JIIk_I-_U/IUI_: Be careful to avoid pinching
fingers between the back of the mounting plate and
the wall.
[_ Tighten all bolts, Pull the plate away from the wall
to help tighten the bolts,