Table of Contents
Advertisement
U3
Q..
!
t-
L0
m
F-
O
O
I
LU
._=l
O
t-
Troubleshooting tips ... Before you call for service
Top burners do not light
or do not burn evenly.
(The front right burner
is designed to have
slightly smaller flames
between the 6 and 9
o'clock positions. This
is normal.)
Burner flames
very
large or yellow
Surface burners light
but oven does not
Possible
Cause
What To Do
Plug on range is not completely
Make sure electrical plug is plugged into a live, properly
inserted in the electrical outlet,
grounded outlet.
Burner slits on the side of the
Remove the burners and clean them. Check the electrode area
burner may be clogged,
for burned-on food or grease. See the Care and cleaning of the
range section.
Improper burner assembly..
Make sure the burner parts are installed correctly. See the Care
and cleaning of the range section.
Improper
air to gas ratio.
The oven gas shut=off valve may
have accidentally
been moved
during cleaning or moving.
If range is connected to LP gas, contact the person who
installed your range or made the conversion.
To check the oven gas shut-off valve, remove the drawer (see
the Care and cleaning of the range section). For lower oven
drawer models, remove the rear access panel by unscrewing
the thumb screws in the upper left and right corners. Look for
the gas shut-off lever at the back of the range.
shownclosed. \
T
/
PULL T OOPEN. k
/
JSealed burnermodels
I
Thumb screws
Lowerovendrawermodels
I
Burners
do not light
Plug on range is not completely
Make sure electrical plug is plugged into a live, properly
inserted in the electrical outlet,
grounded outlet.
Gas supply
not connected or
See the Installation Instructions that came with your range.
turned on.
A fuse in your home may be
Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
Burner parts not replaced
See the Care and Cleaning of the range section.
correctly.
Drawer does not slide
The drawer is out of alignment.
Fully extend the drawer and push it all the way in. See the Care
smoothly or drags
and cleaning of the range section.
Drawer is over4oaded
or load is
Reduce weight. Redistribute drawer contents.
unbalanced.
Lower broiJ drawer will
A fuse in your home may be blown
Replace the fuse or reset the circuit breaker.
not work
or the circuit breaker tripped.
The oven is self=cleaning.
Wait for the self-clean cycle to finish and the oven to cool.
Controls improperly set.
See the broil drawer section.
4-
49
85209
Advertisement
Table of Contents
