LG WT5680HVA Owner's Manual page 32

32 TROUBLESHOOT NG
BEFORE CALLING
FOR SERVICE
(confinued)
Wrinkling
Excessivesudsing
Staining
Washer not unloaded promptly.
Washer overloaded.
Hot and cold water inlet hoses are
reversed.
Too much detergent or incorrect
detergent.
Bleach or softener dispensed too
soon.
Bleach or softener was added di-
rectly to the wash load in the tub.
Washer was not unloaded prompt-
ly.
Clothes were not properly sorted.
ilill ii!i!i_!ii!ii iii!i! i!i!i!_!i!_!_!_!_ !ii!ii!ii!ii!ii!iiiii_il i_!_i_ iiiiiiiiiiiill i_i!_ i!_ii_iii!!ii_ _i!_ii_ i!_ii_i!_ii_i!_i i_i!_ii_ i!_ii_ii !ilil iiii_i_iiiiiiiiiiii iiiiii iiii_ii_ii_ii_ii_iiiii i_ii_ii_ ii_ii_ii_iiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiiil ii!_; _i_i_i!_ _!i_ii_ _!_ii!!ii_iiiiii iiiiiiiiiiiiiiii!ii!ili! i!iiiill iii!!iiiiii!ili!i_i!iiiiii iiiiiiii iiiiiiiiiiiiiii iiiiii_ ii_i!_!i_ii_!i_i iiiiiiiiili!_! _!_!!_!_!!_!! !!!!!! !!!!i !!!i! i!i!i_!_i!!ii!!!!ili i_i_!i_i_ii_ii_ ilili!!_!_!i_! !i_!i_!i _!i_!ii_i!_
Always remove items from the washer as soon as the
cycle is complete.
The washer can be fully loaded, but the tub should not be
tightly packed with items. The lid of the washer should
close easily.
Hot water rinse can set wrinkles in garments. Check the
inlet hose connections.
HE detergents are formulated specifically for High-Effi-
ciency washers and contain suds-reducing agents. Only
use detergent with the High-Efficiency (HE)logo. For de-
tergent quantities refer to the How to Use section.
Dispenser compartment is overfilled causing bleach or
softener to dispense immediately. ALWAYS measure
bleach to prevent overfilling - one cup maximum.
Dispenser drawer closed too quickly causing softener to
dispense immediately.
Always use the dispensers to ensure that laundry prod-
ucts are properly dispensed at the right time in the cycle.
Always remove items from the washer as soon as pos-
sible after the cycle is complete.
Always wash dark colors separately from light colors and
whites to prevent discoloration.
Never wash heavily soiled items washed with lightly
soiled items.
Make sure that the plug is plugged securely into a ground-
ed, 3-prong, 120-VAC, 60-Hz outlet.
Reset circuit breaker or replace fuse. Do not increase
fuse capacity. If the problem is a circuit overload, have it
corrected by a qualified electrician.
Washer will not turn Power cord is not properly plugged
ON _n,
House fuse is blown, circuit break-
er has tripped, or power outage
has occurred.
NOTE: If the washer stopped during a cycle due to a loss of power, the washer will resume
the cycle where it stopped when the power is restored.
Wash cycle time is Ion- The washer automatically adjusts This is normal. The washer adjusts cycle time automati-
get than usual the wash time for the amount of cally to provide optimal results for the selected cycle. The
laundry, water pressure and other time remaining shown in the display is only an estimate.
operating conditions. Actual time may vary.
Musty or mildewy odor Incorrect or too much detergent Use only High-Efficiency {HE) detergent in accordance
in washer has been used. with the manufacturer's instructions.
Inside of tub was not cleaned prop- Run the Tub clean cycle regularly.
erly.
Water leaks Oversudsing of detergent. Oversudsing may create leaks, and may be caused by the
type and amount of detergent used. High-Efficiency de-
tergent is the only detergent recommended. Make sure
that detergent and any additives are put into the correct
dispenser compartments. The normal amount of deter-
gent to use is I/4 to 1/2 of the maximum amount recom-
mended by the detergent manufacturer. Always reduce
the amount of detergent if the load is small or lightly
soiled, or if your water is very soft. Never use more than
the maximum amount recommended by the detergent
manufacturer.