GE GFDL110 Owner's Manual page 24

Before you call for service...
PROBLEM
Time Remaining
jumped to a
lower number
Possible Causes
The estimated time may change
when a smaller load than usual
is drying
What To Do
. This is normal.
Cannot make a
selection and the
dryer beeps twice
The DRYNESS Level, Temp
or OPTIONthat you are
trying to select is incompatible
with the chosen dry cycle
, This is normal.
Dryer is running but
0:00 is displayed in
Time Remaining
The Extended Tumble
option was chosen
This is normal. During extended tumble, the time
remaining is not displayed. The Extended Tumble
option lasts approximately 60 minutes.
Clean Lint Filter (message) Power button was activated
PressStart to begin a dry cycle and the message will
disappear.
Dryer doesn_ heat
Fuse is blown/circuit breaker
is tripped; the dryer may tumble
but not heat
Gas service is off
Check the building's fuse/circuit breaker box and
replace both fuses or reset both breakers. Your dryer
may tumble if only one fuse is blown or one breaker
tripped.
Hake sure gas shutoff at dryer and main shutoff are
fully open.
LP gas supply tank is empty
or there has been a utility
interruption of natural gas
(gas models)
Refillor replace tank. Dryer should heat when utility
service is restored.
Inconsistent drying times
Type of heat
Type of load and
drying conditions
Drying time will vary according to the type of heat used.
If you recently changed from an electric to a gas
(natural or LP)dryer, or vice versa, the drying time
could be different.
The load size,types of fabric, wetness of clothes and the
length and condition of the exhaust system will affect
drying times.
Glow at the rear
of the drum
Heaters behind the drum
, This is normal. Under certain drying conditions and
room ambient lighting, the glow of the heaters may be
visible at the rear of the drum.
Clothes are still wet
and dryer shut off
after a short time
The door was opened mid-cycle.
The load was then removed from
the dryer and a new load put in
without selecting a new cycle
, A dry cycle must be reselected each time a new load
is put in.
Small load
,, When drying 3 items or less,choose Speed Dry or
Time Dry.
Load was already dry except . Choose Speed Dry or Time Dry to dry damp collars
for collars and waistbands and waistbands. In the future, when drying a load with
collars and waistbands, choose Hare Dry.
Dryer is not level . Hove dryer to an even floor space or adjust leveling legs
as necessary until even.
Clothes are wrinkled Overdrying . Select a shorter drying time.
. Remove items while they still hold a slight amount
of moisture. Select a Less Dry or Damp setting.
Letting items sit in dryer after . Remove items when cycle ends and fold or hang
cycle ends immediately, or use the Extended Tumble option.
2/4 Overloading . Separate large loads into smaller ones.