Table of Contents
Advertisement
（ After setting 8960 ( EGSM / DCS )
1. After setting, prepare the call setup Display
2. Using an Originate Call, make a call.
3. Confirm the display "connected"
4. start the measuring
（ 8960 & spectrum analyzer
- spectrum analyzer : testing method = the way using an Osciliscope
- 8960 : connect using RF Cable between 8960 & RF Connector in board.
8-4-1. GSM850 RX
(down & up at picture)
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
8-35
Level 3 Repair
Advertisement
Table of Contents
