Advertisement
Removing
or
installing
t h e
outer and inner
sleeves
CAUTION :
*Always be sure that the tool is switched off and unplugged before removing or installing
Be careful not to allow foreign matter to enter the insides of the tool when removing
the outer and inner sleeves.
or installing the outer and inner
sleeves.
The outer sleeve
M20
and
inner sleeve
3/4" are factory-installed.
I f you need other sizes for your work, replace the
sleeves as
follows.
Inner sleeve spring
Loosen the two screws while holding the
outer
sleeve.
The outer and inner sleeves
will
be pushed up by the springs built into
the tool.
I
= -
\
\
Press the pin down to remove the inner sleeve from the outer sleeve. Be careful not to
drop the inner
sleeve
when removing
it.
Do not remove the inner sleeve spring, tip rod
and tip rod spring from the tool.
1
-
Inner sleeve
Hold the inner
sleeve
with the pin facing
upward.
Place
the outer
sleeve
over the
inner
sleeve.
Press the pin to secure the
inner
sleeve.
Outer sleeve
in
sleeve
5
Advertisement
