Page 1
Angle Grinder 100 mm (4”) MODEL 9526PBH 115 mm (4-1/2”) MODEL 9527PB 125 mm (5”) MODEL 9528PB I N S T R U C T I O N WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
3. Keep bystanders, children, and visitors away while operating a power tool. Distrac- tions can cause you to lose control. 9526PBH 10,000/min 275 mm (10-7/8”) 275 mm (10-7/8”) 1.5 kg (3.3 lbs) 1.5 kg (3.3 lbs)
Page 3
5. Avoid body contact with grounded sur- faces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is grounded. 6. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock.
Not More Than SPECIFIC SAFETY RULES DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to grinder safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. 1. Always use proper guard with grinding wheel.
Page 5
Damage to these parts could result in wheel breakage. 9. NEVER use tool with wood cutting blades or other sawblades. Such blades when used on a grinder frequently kick and cause loss of control leading to personal injury. 10. Hold the tool firmly.
FUNCTIONAL DESCRIPTION 001021 1. Shaft lock 001034 1. Lock-off button 2. Switch trigger 3. Lock-on button ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Shaft lock CAUTION: •...
001083 1. Lock nut wrench 2. Shaft lock 001095 1. Lock nut 2. Flex wheel 3. Plastic pad 4. Inner flange 001106 1. Lock nut 2. Abrasive disc 3. Rubber pad OPERATION To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise.
Page 9
15 degrees to the workpiece surface. During the break-in period with a new wheel, do not work the grinder in the B direction or it will cut into the workpiece. Once the edge of the wheel has been rounded off by use, the wheel may be worked in both A and B direction.
Page 10
001228 1. Wire wheel brush 001116 1. Lock nut 2. Abrasive cut-off wheel 3. Inner flange 4. Wheel guard for cut-off wheel Operation with wire wheel brush (optional accessory) CAUTION: • Check operation of wire wheel brush by running tool with no load, insuring that no one is in front of or in line with the wire wheel brush.
Your tool is supplied with a guard for use with a depressed center grinding wheel, multi-disc, flex wheel and wire wheel brush. A cut-off wheel can also be used with an optional guard. If you decide to use your Makita grinder with approved accessories which you purchase...
Page 12
Rubber pad 76 Sanding lock nut 10-30 Lock nut wrench 20 from your Makita distributor or factory service center, be sure to obtain and use all necessary fasteners and guards as recommended in this manual. Your failure to do so could result in personal injury to you and others.
WARRANTY. “The Makita Warranty is the only and the entire written warranty given by Makita for the Makita tools. No dealer or his agent or employee is authorized to extend or enlarge upon this warranty by any verbal or written statement or advertisement.”...