Table of Contents
Advertisement
M.I.B III (MB Intelligent BIOS III) Menu
This page enables you to set the clock speed and system bus for your system. The
clock speed and system bus are determined by the kind of processor you have
installed in your system.
Main
Advanced
CPU Ratio/Voltage
Memory Clock
Memory Timing Configuration
Memory Clock DCTO is :
Command Rate
CAS# Latency (tCL)
RAS# to CAS# Delay (tRCD)
Row Precharge Time (tRP)
RAS# Active Time ( tRAS)
Memory Clock DCT1 is :
Command Rate
CAS# Latency (tCL)
RAS# to CAS# Delay (tRCD)
Row Precharge Time (tRP)
RAS# Active Time ( tRAS)
CPU Over-clocking Func.
Spread Spectrum
IGD Over-clocking Func.
CPU Voltage
DIMM Voltage
NB Voltage
CPU Ratio/Voltage (Auto)
This item allows users to control non turbo CPU ratio/Voltage.
Memory Clock (Auto)
This item is used to set the memory clock.
Memory Timing Configuration(Auto)
This item is used to set the memory Timing Configuration.
Memory Clock DCTO is (None)
This item shows current memory clock of DCTO.
Command Rate (N/A)
This item allows users to set command rate.
CAS# Latency(tCL) (N/A)
This item determines the operation of DDR SDRAM memory CAS(column address
strobe). It is recommanded that you leave this item at the default value. The 2Tsetting
requires faster memory that specifically supports this mode.
RAS# to CAS# Delay(tRCD) (N/A)
This item specifies the RAS# to CAS# delay to Rd/Wr command to the same bank.
Row Precharge Time(tRP) (N/A)
This item specifies Row precharge to Active or Auto-Refresh of the same bank.
RAS# Active Time(tRAS) (N/A)
This item specifies the RAS# active time.
Chipset
M.I.B III
Auto
Auto
Auto
None
N/A
N/A
N/A
N/A
N/A
(DDR-1333/667Mhz)
1T
9 CLK
9 CLK
9 CLK
24 CLK
Disabled
Disabled
Disabled
Default
Default
Default
Using BIOS
Boot
Security
: Select Screen
/Click: Select Item
Enter/Dbl Click : Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit
45
Save&Exit
Advertisement
Table of Contents
