Table of Contents
Advertisement
1-2. TEMPORARILY
SEITING
UP AND CONNECTING
CP-I PWB ASSEMBLY
The following is an example of how to place and connect the main board without a jig, when repairing the CP-1 PWB assembly.
1.
Place the mechanism unit and main board up side down as
2.
Operete the unit usirm the buttons on TM-1 PWB or the
a whole on a flat surface with foil side of the main board
remote control.
facing up.
M-PF2LNTA-4
TM-1
CP-1
PWB Assembly
(Foil side)
\
/1
Twminai
Rnnrrl
. .. . . . .
--",-
Mechanism
Main Unit
Fig. 1-1-4
1-3. INSTALLATION
OF THE FRONT PANEL
When installing the front panel to the chassis after repaires and adjustments.
1.
Pressing
down the door opener lever of the mechanism
Note: Opened cassette door position does not install the front
main unit.
panel to the chassis.
2.
Set the cassette door to half-opened state as shown in Fig.
1-1-5, and install the front panel to the chassis.
M-MA41U-5
Jutted Dart of
(Position
B)
Fig. 1-1-5
I
–7-
Advertisement
Table of Contents
