Installation Hardware; Tools; Mounting Space - Master Chef MCO160UWF Installation Manual

Installation Hardware

The following is a list of parts you may need for installing your Over-the-Range
microwave oven. You will find the installation hardware contained in a packet with the
unit. Check to make sure you have all these parts. Use this time to become familiar
with each piece.
Image Part & Description
Lag screws
(1/4" x 2")
Toggle Bolts and Nuts
3/16 x 3"
Cabinet Mounting Bolts
1/4" x 3-1/8
Washer (3/4")
Nylon Grommet
(for metal cabinets)
Damper

Mounting Space

30" more than
from cooking
surface
66" or more
from the floor to
the top of the
microwave
oven
Q'ty Image Part & Description
Top Cabinet
3 Top Cabinet Template
Template
3 Rear Wall Template
Wall Template
Installation
3 Installation Manul
Manual
Use and
3 Use and Care Manual
Care
Manual
2 Roller Guide
Grease Filters
1
OTR
30" 2"
Q'ty
1
1
1
1
1
2
max, 12
"
Back splash
2

Tools

The following tools may be needed for
installation of your microwave oven.
Phillips screwdrivers, Electric Drill
Motor, 1/2" & 5/8" Wood Bits & 3/16"
Drill Bit, Saw to cut exhaust opening, (if
needed) or Jig Saw, Tin Snips (if
needed), Pencil, Tape Measure, Paper
Tape & Duct Tape.
Your Over-the-Range microwave oven
requires mounting space on a wall as
shown.
1. A minimum of 30" between wall
hung side cabinets is required for
installation. Make sure the bottom
edge of the top cabinet is at least 66"
from the floor and 30" from the
cooking surface. And the depth of
the cabinet is required less than 12
inch. (max.12inch)
2. For easier access to the hood lamp,
the bottom of the microwave oven
should be at least 2" above the range
backsplash.
3. If you are going to vent your
microwave oven to the outside, see
exhaust duct preparation.
4. Designed to be installed in 30" wide
cabinet opening.