Table of Contents
Advertisement
For more information, see "Electrostatic Discharge (on page 13)."
Depending on the server model, remove or open the server access panel.
1.
WARNING:
internal system components to cool before touching them.
Locate the PCIe bus expansion slots, and select the slot that you want to use. (For more information,
2.
see the server documentation.)
Depending on the server model, remove the retaining screw or open the expansion slot latch that
3.
secures the PCIe slot.
Remove the slot cover and save it. You will need to put it back if you decide to remove the adapter
4.
and leave the slot empty.
Insert the adapter into the slot, and press it firmly into place. The contacts on the adapter edge must
5.
be fully seated in the system board connector.
Depending on the server model, secure the adapter by replacing the retaining screw or by closing
6.
the slot latch.
Connecting the adapter
Cables for connecting the adapter to other devices are provided with most HP server products. The
following table lists cables that you can use with this adapter. All HP cables are keyed to ensure correct
installation.
Type of cable
External Mini SAS
External Mini SAS
External Mini SAS
External Mini SAS
You can order extra cables from an authorized HP reseller or authorized HP service provider. If the cable
that you need is not listed in the preceding table, or if you need additional ordering information, see the
HP website (http://www.hp.com).
Completing the installation procedure
Verify that all cables are routed correctly and are not restricting other components or being pinched
1.
by them. For the correct cable routing, see the server documentation.
Connect peripheral devices to the server.
2.
Plug the AC power cord into the server.
3.
Plug the other end of the power cord into a grounded AC outlet.
4.
Power on any peripheral devices attached to the server.
5.
Power up the server.
6.
Install the adapter drivers. The drivers are available on the CD in the adapter kit or the HP website
7.
(http://www.hp.com). Instructions are provided with the driver files.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
Length
1.0 m (3.3 ft)
2.0 m (6.6 ft)
4.0 m (13 ft)
6.0 m (20 ft)
Cable kit
part number
407337-002
407339-B21
432238-B21
432239-B21
Installation procedure 6
Advertisement
Table of Contents
