Electronic Type Model - LG C6000 Service Manual

ELECTRONIC TYPE MODEL

Precaution: The Remote Control unit will not function properly if bright light strikes the sensor window of the air conditioner or
if there are obstacles between the Remote Control unit and the air conditioner.
1. POWER
• To turn the air conditioner ON, push this button. To turn the
air conditioner OFF, push the button again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cool mode, high fan
speed, temperature setting at 22˚C(72˚F).
2. TEMPERATURE SETTING
• Use this button to automatically control the temperature of
the room.
The temperature can be set within a range of 16˚C(60°F) to
30˚C(86°F) by increments of 1˚C(1°F).
3. MODE
- Every time you push this button, it will cycle through the fol-
lowing modes: COOL, ENERGY SAVER, FAN and DRY.
- ENERGY SAVER
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and the
unit will check the room air to determine if cooling is need-
ed.
AUTO RESTART
When power is restored after an electrical power failure, the unit will begin to run at its last setting.
6
1
°C
4 2
3
Dry
5
5
4. FAN SPEED
• Every time you push this button, it advances the setting as
follows: {High(F3) ¡ Low(F1) ¡ Med(F2) ¡ High(F3)}
5. TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• With unit running, use Timer to set number of hours until
shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting will raise 1°C(2°F) after 30 min, and
1°C(2°F) after another 30 min.
• Every time you push Timer button, it advances the Timer
setting as follows: 1 Hour ¡ 2 Hours ¡ etc. ¡ 12 Hours
maximum.
- START TIME
• With unit not running, use timer to set number of hours
before unit starts.
• Every time you push Timer button, it advances the Timer
setting as follows: 1 Hour ¡ 2 Hours ¡ etc. ¡ 12 Hours
maximum.
6. REMOTE CONTROL SENSOR
Operation
Power
1
Temp
2
Fan Speed
4
Timer Mode
3
Service Manual 9