Kia 2016 sedona Owner's Manual page 605

1. Open the hood.
2. Remove the front cover(1) and
headlamp assembly nuts(2).
3. Remove the headlamp assembly
from the body of the vehicle
4. Remove the headlamp bulb cover
by turning it counterclockwise.
5. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
6. Remove the bulb by pulling it out.
7. Inset a new bulb by inserting it into
the socket.
8. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
9. Install the headlamp bulb cover by
turning it clockwise.
Turn signal lamp/Position lamp
Follow the steps 1 to 3 from the pre-
vious page.
4. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
5. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket
I n f o r ma t i o n P r o v i d e d b y :
6. Insert a new bulb by inserting it
into the socket and rotating it until
it locks into place.
7. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
✽ ✽ NOTICE
If bulb will not rotate inside socket,
remove bulb, rotate 180°, and try
OYP074056N
again.
Maintenance
7 77