Download  Print this page

Residual Risks; Battery Diagnostics - Black & Decker WW100 Original Instructions Manual

Hide thumbs

Advertisement

Do not probe the charger.
u
The appliance/tool/battery must be placed in a well venti-
u
lated area when charging.
Safety of others
This appliance is not intended for use by persons (incud-
u
ing children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concern-
ing the use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not
u
play with the appliance.

Residual risks.

Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any rotating/moving parts.
u
Injuries caused when changing any parts, blades or
u
accessories.
Injuries caused by prolonged use of a tool. When
u
using any tool for prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed
u
when using your tool (example:- working with wood,
especially oak, beech and MDF.).
Electrical safety
Your charger has been designed for a specific voltage. Always
check that the mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the charger unit with
a regular mains plug.
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the adapter
unit with a regular mains plug.
Symbols on Charger
Short circuit proof safety isolating transformer.
SMPS
(Original instructions)
$
The charging base is intended for indoor use
only.
+
Labels on appliance
Read all of this manual carefully before
using the appliance
Only use with charger SSA-GP-05
LED Patterns Charging
LED Patterns In use

Battery diagnostics

If the appliance detects a weak battery, the charging indicator
will flash at a fast rate when the power button is activated.
Proceed as follows:
Plug in the charger. Switch on at the mains.
u
Leave the appliance to charge.
u
If the appliance detects a damaged battery, the charging
indicator will flash at a fast rate when the appliance is on
charge. Proceed as follows:
Take the appliance and the charger to be tested at an
u
authorised services centre.
Note: It may take as long as 60 minutes to determine that
the battery is defective. If the battery is too hot or too
cold, the LED will alternately blink, fast and slow, one
flash at each speed and repeat.
ENGLISH
Charging
Battery Fault
Battery low
Battery Empty
3

Advertisement

loading

  Also See for Black & Decker WW100

  Related Manuals for Black & Decker WW100