Pioneer X-SMC01-K Operating Instructions Manual page 31

Additional information
Problem Check
Unable to connect to a Are there any devices nearby that
Bluetooth capable device, no emit electromagnetic waves in the
sound comes out at all or 2.4 GHz band (microwaves, wireless
sound cuts out when LAN devices, other Bluetooth capable
connected. (X-SMC01BT) devices etc.)?
Is the Bluetooth capable device too
far away from the unit, or is there
something between them?
Is the Bluetooth capable device set to
a mode that allows for Bluetooth
wireless communication?
Has pairing not been completed
successfully, or has either the unit or
the Bluetooth capable device erased
the previous pairing setting?
Does the device you are trying to
connect have a supported profile?
The panel for the electric
slide CD door has fallen off.
Remedy
If so, either move these devices away from the unit, or stop using
other devices that emit electromagnetic waves.
Place the Bluetooth capable device inside the same room, with no
obstacles between them, and within a range of 10 m *.
* Only a suggested range. The actual possible communication
range may change depending upon the surrounding environment.
Check the settings on the Bluetooth capable device.
Perform the pairing operation again.
Please use a Bluetooth capable device that supports A2DP .
It can be attached as follows.
Align the line below the arrow and the bottom of the panel, then
slide downward using both hands until you hear a clicking sound.
* The panel is designed to be removable for repairs.
Note
• If the panel is not attached correctly, the panel may not
open or close properly. It may also cause irregular noise,
so make sure the panel is positioned correctly.
• Disconnect from the AC outlet before attaching the
panel.
11
Arrows
31
En