Step 6: Install Nomad Ii Driver; For Windows Users Only; Step 7: Verify Correct Installation Of Nomad Ii Driver; For Windows Users - Creative NOMAD IIc User Manual

Step 6: Install NOMAD II
Driver
NOMAD IIc uses the "NOMAD II"
driver.
Skip this step if you are a Macintosh
user; installing the software as
instructed in "Step 4: Install Software"
on page 2-2, would have already
installed the drivers necessary for your
NOMAD IIc to work with your
Macintosh.

For Windows users only

Once you have connected your NOMAD IIc
the dialog box similar to
player to your PC,
Figure 2-3 appears.
Figure 2-3: Add New Hardware Wizard dialog
box.
1. Click the Next button.
Figure 2-4: Installation of Creative NOMAD II
driver is completed.
2. Select the Search for the best driver for
your device. (Recommended) option and
click the Next button.
3. Clear the Floppy disk drives check box
and select the CD-ROM drive option.
4. Click the Next button twice in succession.
The dialog box similar to Figure 2-4
appears.
5. Click the Finish button.
Step 7: Verify Correct
Installation of NOMAD II
Driver

For Windows users

1. Click Start -> Settings -> Control Panel.
2. In the Control Panel window,
double-click the System icon.
3. In the System Properties dialog box,
click the Device Manager tab.
4. In the Device Manager tabbed page,
double-click Universal Serial Bus
controllers, and then check that Creative
NOMAD II is present as shown in Figure
2-5 below.
Figure 2-5: Verify that Creative NOMAD II
driver is installed correctly.
Setting Up Your NOMAD IIc Player 2-5