Bang & Olufsen beocom 1401 User Manual

1 2 3
ABC DEF
4 5 6
GHI JKL MNO
7 8 9
PQRS TUV WXYZ
0
R
Rdl Mem
Flash
Vol Vol Enter
Beocom Beocom
BeoCom 1401
RINGING SIGNAL
BeoCom 1401 has 10 different settings
for the ringing signal, consisting of 3
levels, 3 melodies and the ringing signal
disconnected.
Low Medium High
Slow 1 2 3
Normal 4 5 6
Fast 7 8 9
Disconnected 0
SETTING THE RINGING SIGNAL
Press Enter
Press
Press 0-9 to select a setting
Press Enter
When the ringing signal is disconnected
(setting 0), it is automatically
reconnected the first time you lift off
the handset and place it in the base
again.
ADJUSTING THE VOLUME
During a call, you can adjust the
handset volume in 5 steps by pressing
+ –
the and buttons. All calls start at
the medium volume level.
+
Press to increase the volume
–
Press to decrease the volume
REDIALLING
Press Rdl to redial the last number
called
Numbers with up to 31 digits can be
memorized.
Numbers stored in memory cannot be
called by pressing Rdl.
In order to ensure that the last
number called is stored correctly in
the memory of BeoCom 1401 and can
be redialled by pressing Rdl, the
handset must have been placed in
the base (or the switch off key on the
bottom side of the handset pressed)
for at least 1 second.
MICROPHONE
Press to mute the
microphone
A beeping signal in the handset
indicates that the microphone is
muted.
Press to connect the
microphone
Please note! Pressing any other key
once or twice will connect the micro-
phone as well.
MEMORY
BeoCom 1401 memorizes 10 tele-
phone numbers which can be stored
with code numbers from 0 to 9.
Numbers of up to 21 digits can be
memorized.
If the telephone line is disconnected
for more than 1 hour, numbers
stored in the memory will be deleted.
This may also happen when using a
computer modem or another
telephone on the same line.
STORING PHONE NUMBERS
Press Enter
Press Mem
Enter the code number (0-9)
Enter the phone number
Press Enter
DIALLING A STORED NUMBER
Press Mem
Enter the code number (0-9)
DELETING A STORED NUMBER
A stored number is deleted by
storing a new number with the same
code number.
SWITCHBOARD
STORING PHONE NUMBERS
Press Enter
Press Mem
Enter the code number (0-9)
Enter the phone number
Press Enter
DIALLING A STORED NUMBER
Press the prefix
Press Mem
Enter the code number (0-9)
REDIALLING A NUMBER
Press the prefix
Press Rdl
If the R-button is used for recalls,
subsequent entries will not be stored
for redialling.
Please note!
The R/Flash-button may also be
referred to in some instances as the
Recall-button.