Service Mode - Magnetek 188-10130 Instruction Manual

Parameter
% of MOTOR FLA
MOTOR INSULATION* Displays the insulation level of the motor's windings
THERMISTOR RES.*
ANALOG OUTPUT Normal=analog output increases with increasing current
Inverted=analog output decreases with increasing current
* Requires an option card for these parameters to be displayed. If there are no option cards, the display will
read,"Option Card—Not Installed".
Parameter
STORE ENABLE DEFAULT
PARAMET.
RESET STATISTICS
PROGRAM VERSION
VOLTAGE ADJUST.
CURRENT ADJUST.
DISPLAY MODE
Description
The operating current as a % of the motor FLA
Displays the motor thermistor resistance

SERVICE MODE

Description
Access: To Enter or Exit the Service Mode press "Mode" &
Reset ALL parameters to default settings
Reset statistical data.
View the software version.
Factory calibration of phase to phase voltage.
Factory calibration of current.
Default Value
n/a
Option card-not installed
Option card-not installed
Option card-not
installed*
simultaneously.
Press "Mode" & Store simultaneously to save default
parameters.
Press "Reset" & "Store" simultaneously to reset
statistic parameters.
RVS-DX, Digital Soft Starter Instruction Manual—4/01/04
Range Access
0-100% Display only
? Option card
? Option card
Normal or Inverted Option card
Default
STRT.DN-xxxxxx
xxx VOLT
xxx% of FLC
6-5