Advertisement
Toy Arch Mounting Instructions
Instrucciones de Montaje del Arco de Juguetes
Instructions de montage du l'arceau de jouets
1 1
Pivot the clamp at each end of the toy arch into the extended position.
Gire la prensa de sujeción en cada extremo del arco de juguetes hasta que esté en
posición extendida.
Faire pivoter les pinces à chaque extrémité de l'arceau de jouets en position étendue.
Click • Clic • Clic
2 2
Open both clamps on the toy arch.
Abra ambas prensas de sujeción del arco
de juguetes.
Ouvrir chaque pince sur l'arceau de jouets.
– 4 –
Care and Cleaning • Cuidado y limpieza
Entretien et nettoyage
•
Clean before use with a damp cloth and mild soap. Air dry. Do NOT immerse in water.
•
Limpie antes de usar con un paño húmedo y jabón suave antes de usar. Deje secar al aire.
NO sumerja en agua.
•
Nettoyer avec un chiffon humide et du savon doux avant utilisation. Séchez à l'air.
N'immergez PAS dans l'eau.
FCC Statement • Declaración de la FCC • Déclaration FCC
This device complies with Part 15 of the FCC rules. Operation is subject to the following
EN
two conditions:
1
this device may not cause harmful interference, and
2
this device must accept any interference received, including interference that may
cause undesired operation.
WARNING: Changes or modifi cations to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
– 9 –
Advertisement
