Engine Power Messages; Fuel System Messages; Key And Lock Messages - GMC 2016 Yukon XL Denali Owner's Manual

Hide thumbs Also See for 2016 Yukon XL Denali:
Table of Contents

Advertisement

and allow the vehicle to idle until it
cools down. See Engine Coolant
Temperature Gauge 0 124.
OIL PRESSURE LOW STOP
ENGINE
This message displays if low oil
pressure levels occur. Stop the
vehicle as soon as safely possible
and do not operate it until the cause
of the low oil pressure has been
corrected. Check the oil as soon as
possible and have the vehicle
serviced by your dealer. See Engine
Oil 0 265.

Engine Power Messages

ENGINE POWER IS REDUCED
This message displays and a chime
may sound when the cooling system
temperature gets too hot and the
engine further enters the engine
coolant protection mode. See
Engine Overheating 0 273 for more
information.
This message also displays when
the vehicle's engine power is
reduced. Reduced engine power
can affect the vehicle's ability to
accelerate. If this message is on,
but there is no reduction in
performance, proceed to your
destination. The performance may
be reduced the next time the vehicle
is driven. The vehicle may be driven
at a reduced speed while this
message is on, but acceleration and
speed may be reduced. Anytime
this message stays on, the vehicle
should be taken to your dealer for
service as soon as possible.

Fuel System Messages

FUEL LEVEL LOW
This message displays when the
vehicle is low on fuel. Refuel as
soon as possible.

Key and Lock Messages

NO REMOTE KEY WAS
DETECTED PLACE KEY IN
TRANSMITTER POCKET THEN
START YOUR VEHICLE
This message displays when trying
to start the vehicle if an RKE
transmitter is not detected. The
transmitter battery may be weak.
Instruments and Controls
See Starting the Vehicle with a Low
Transmitter Battery under Remote
Keyless Entry (RKE) System
Operation 0 27.
NO REMOTE DETECTED
This message displays when the
transmitter battery may be weak.
See Starting the Vehicle with a Low
Transmitter Battery under Remote
Keyless Entry (RKE) System
Operation 0 27.
NO REMOTE DETECTED
PRESS BRAKE TO RESTART
This message displays when
attempting to turn off the vehicle
and the RKE transmitter is no longer
detected. Restarting is allowed
without the RKE transmitter for
five minutes. Press the brake pedal
to restart the vehicle.
NUMBER OF KEYS
PROGRAMMED
This message displays when
programming new keys to the
vehicle.
147

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents