Tandy 6000 Service Manual page 19

Service Manual
3.2 Bezel/CRT Assembly Removal
1. Loosen the three (3) screws at the front of the unit
that attach the Bezel/CRT Assembly to the Base Assembly.
See Figure 3-1, which shows the location of these
screws.
2. Remove the two
Support Structure, which attach the Bezel/CRT Assembly
support bar to the Drive Support Structure.
3. Remove the two
which attach the CRT Monitor PCB Bracket to the Base
Assembly.
4. Separate the two units (Base and Bezel/CRT) by
disconnecting the attaching harnesses (one to the
Video/Keyboard Interface PCB and an in-line connector to
the Power Supply Assembly).
5. Remove the ground wire spade lug terminal from the CRT
Monitor PCB. This completely separates the Bezel/CRT
Assembly from the Base Assembly.
3.3 CRT Removal
1. Disconnect the tube socket from the rear of the CRT.
2. Disconnect the deflection coil wire connector at the CRT
Monitor PCB.
Make sure the high voltage is discharged
from the CRT (use grounded screwdriver
to discharge).
3. Disconnect the high voltage clip.
4. Disconnect the in-line connector which attaches the CRT
Monitor PCB to the ground wire around the rear of the
CRT.
TANDY COMPUTER PRODUCTS
(2) screws, at the top of the Drive
(2) screws, at the left of the unit,
CAUTION
- 11 -
TANDY 6000/6000-HD
---------------------------------------------------------------------