Table of Contents
Advertisement
** If you use a 2-channel speaker, please connect the speaker's plug into "Front Speaker Jack". See the table below
for connection details in accordance with the type of speaker you use.
Audio Output
Front Speaker
Channels
2
4
6
8
To enable Multi-Streaming, you need to connect a front panel audio cable to the
front panel audio header. Ater restarting your computer, you will ind the "Mixer"
tool on your system. Please select "Mixer ToolBox"
multi-streaming", and click "ok". Choose "2CH", "4CH", "6CH", or "8CH" and then
you are allowed to select "Realtek HDA Primary output" to use the Rear Speaker,
Central/Bass, and Front Speaker, or select "Realtek HDA Audio 2nd output" to use
the front panel audio.
*** Please use a 19V power adapter for the DC jack. his jack accepts dual barrel plugs with an inner diameter of
2.5 mm and an outer diameter of 5.5 mm, where the inner contact is +19V (±10%) DC and the shell is GND.
Please refer to below hardware coniguration for the estimated adapter power.
DRAM
HDD
PCIe Card
1
1
0
1
2
0
2
4
0
1
1
<20W
1
2
<20W
1
1
<40W
If you install 4 HDDs, please use the 90W DC-in 19V power adapter.
Due to the power limitation and PCIe bandwidth (x1), the VGA card is not supported.
When you use the DC-in power adapter, please use the onboard SATA power connector to get the power for
HDDs.
Rear Speaker
(No. 7)
(No. 5)
V
--
V
V
V
V
V
V
Estimated Adapter Power
35W
50W
84W
60W
75W
85W
Central / Bass
Side Speaker
(No. 9)
(No. 4)
--
--
V
V
, click "Enable playback
N3150DC-ITX
--
--
--
V
5.5 mm
2.5 mm
8
Advertisement
Table of Contents
