Table of Contents
Advertisement
T
he influence of magnetic fields
and changes in the position of the
TV may cause screen colors not to
line up properly. The result on your
TV screen will be red or blue colors
appearing around the edges of
images.
If various images on the entire picture
have red outlines, adjust the CON-
VERGE RED control. Then if any red
outlines remain, adjust the MULTI-
POINT RED control.
If various images on the entire picture
have blue outlines, adjust the CON-
VERGE BLUE control. Then if any
blue outlines remain, adjust the MUL-
TIPOINT BLUE control.
Use the UNDO MULTIPOINT control
if you want to restore the picture
screen to the way it was before you
made Multipoint adjustments.
NOTE: After turning the TV set on,
allow it to warm up for 15 minutes
before adjusting the Convergence
controls.
BEGIN
Press the MENU button on the
remote to show the on-screen menu.
PICTURE will be highlighted.
Press the CURSOR RIGHT but-
ton to enter the PICTURE menu.
Press the CURSOR DOWN but-
ton repeatedly until CONVER-
GENCE is selected.
Press the CURSOR RIGHT but-
ton to enter the CONVERGENCE
menu.
Press the CURSOR RIGHT but-
ton to enter CONVERGE RED mode.
Press the CURSOR LEFT,
RIGHT, UP, or DOWN button to
adjust the cross image until the color
outline around it is gone.
Press the i+ button to exit the
menu from the screen.
C
R
ONVERGE
ED
PICTURE
TINT
CONVERGE RED
COLOR TEMP
CONVERGE BLUE
DNR
MULTIPOINT RED
IMAGEMAX
MULTIPOINT BLUE
CONVERGENCE
SAVE MULTIPOINT
AV
i+
SAP
TV
1
2
VCR
ACC
4
5
8
7
SMART
0
MENU
PIP
INCR. SURR.
PIP CH
UP
PICTURE
CONVERGENCE
CONVERGE RED
CONVERGE BLUE
MULTIPOINT RED
MULTIPOINT BLUE
SAVE MULTIPOINT
9
Picture Menu • The Convergence Control
/B
LUE
PICTURE
CONVERGENCE
CONVERGE RED
CONVERGE BLUE
MULTIPOINT RED
MULTIPOINT BLUE
SAVE MULTIPOINT
3
6
9
SMART
SURF
CH
VERGE BLUE control the
A/CH
same way you would the CON-
VERGE RED control.
DN
CONVERGE BLUE
CONVERGE RED
CONVERGE RED
S
H
MART
ELP
You can adjust the CON-
CONVERGE BLUE
Advertisement
Table of Contents
