Table of Contents
Advertisement
Station Transfer
4
Determine Appropriate Handle
Position
After you press & release the SEL button once, the SEL
light & appropriate gear lights will blink—blink rate
will depend on control handle setting at the station
taking control.
• Slow blink: handles not in appropriate position.
• Quick blink: handles are in the appropriate position;
proceed to step six.
NEUTRAL
NEUTRAL
SLOW
This procedure allows the propulsion system to be transferred from one helm control station
to the other.
5
Prepare the Station Handles
Control handles must be in the appropriate handle
position at the station taking control in order for
transfer to be completed (see chart below). When
handles are in appropriate handle position for
transfer, the SEL light will begin to flash quickly.
Control handles at the
active station can be
in any position prior to
transferring control to
another station.
The following positions are acceptable for transferring station control:
NEUTRAL
WARM
SLOW
ACTIVE STATION
WARM
• In neutral
• In gear / idle
• In gear / with speed
6
The
(not blinking) after
Control handles at "station
time to indicate this station is in control.
taking control" must be in
appropriate handle position
to transfer control to it.
You can always take control when inactive
DESIRED STATION
handle is at the neutral position, no matter
• In neutral / idle
where the active handle is located.
• In same gear
• Same or slower speed
setting
Use the Desired Station
Press and release the SEL button a second time at
the station where you want to take control. The new
control station is now the active station and has
control of the engine and transmission.
light and appropriate gear lights will be fully on
SEL
button is pressed for the second
SEL
NEUTRAL
WARM
SLOW
NOTE:
12
Advertisement
Table of Contents
