Safety - Welding Industries Malaysia WIM200 Instruction Manual

SAFETY OBSERVATION
Support the gas cylinder with
chain provided in the ma-
chine
Open cylinder valve and
check the cylinder valve
pressure ( Must be greater
2
than 10bar 150Ib/in )
Clean the material to be
welded with a wire brush.
Ensure a fire ex-
tinguisher is
nearby in case
of fire.
© Welding Industries Malaysia Sdn. Bhd. reserves all rights even in the event of industrial property rights. We reserve all rights of dis-
posal such as copying and passing on to third parties. Specification may vary from country to country.
Protect eyes and open cylinder
valve to remove any dirt in valve
socket.
Shut the cylinder valve.
Place
earth lead clamp on a clean area of
the work piece.
Fit gas regulator to cylinder
head and tighten using correct
size spanner. OVERTIGHTEN
will cause 'O' RING in the regu-
lator to spoil.
Fit gas hose to regulator and
open cylinder valve. Set flow
15Lt Min. Bigger torch may need
20Lt Min.
the
Keep the gap between pieces to
be welded to a minimum.
Clean the welding area
and check a fire extin-
guisher is available.
V1.1.06