Page 2
B. Hosetail & Nut C. Ball Joint D. Outlet adaptor E. Pump F. Filter Cage G. Pump cradle (Aquaforce 1000 only) blocking the inlets of the pump or obstructing the INTRODUCTION impeller. Remove the obstruction and wait for the pump The pump is electrically operated and is designed to pump to cool down.
Page 3
responsible for their safety. Children should be 4. A 10mA or 30mA Residual Current Device (RCD) Must supervised to ensure that they do not play with the be fitted to the mains supply. appliance. (Australia & NZ only) This appliance is not 5.
TYPICAL INSTALLATION Fig. 3 PUMP ASSEMBLY & INSTALLATION 4.Remove the mains supply cable and ASSEMBLY unwind. 1. Open the clips at either end of the 5. Screw the outlet adaptor onto the strainer cage and open the cage. outlet of the pump. Do not over 2.
Page 5
9. Checking that the ball joint’s inlet and outlet bosses are in line, firmly screw the nut on to the screw thread on the outlet adaptor (Fig 8). Fig. 8 10. Using small bore hoses leads to diameter hose should be used when excessive restriction of the water flow.
Page 6
Pull the rotor assembly (c) out of the motor body (d). Important! Take extra care so as to not drop any of the The Hozelock Cyprio range of Aquaforce pumps have been small components. See Fig 15-a for assembly of the 1000 designed to allow fast and easy maintenance.
This guarantee is not transferable. It does not affect your statutory rights. To obtain the benefits of the guarantee, firstly contact Hozelock Cyprio Consumer Services who may request that the pump is sent along with proof of purchase directly to the address below.
Page 8
Midpoint Park, Birmingham B76 1AB. England. replacing old appliances with new ones, Tel: +44 (0)121 313 1122 the retailer is legally obligated to take www.hozelock.com back your old appliance for disposal at The Aquatics Division of Hozelock Group least free of charge. 43385-001...
Need help?
Do you have a question about the Aquaforce 1000 and is the answer not in the manual?
Questions and answers