JL Audio Dominion d108 Owner's Manual page 22

STEREO RECEIVER
SPEAKER
OUTPUTS
L + R +
– –
(L) (R)
TO SATELLITE
SPEAKERS
STEREO RECEIVER
SPEAKER
OUTPUTS
L + R +
– –
WARNING! TURN OFF THE DOMINION™(s) AND ALL OTHER EQUIPMENT
IN THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
Page 22
DOMINION™ REAR PANEL
OR OR
DOMINION™ REAR PANEL
SYSTEM CONNECTION DIAGRAM 5:
Connecting one Dominion™ to a
Receiver via the Speaker Level Inputs
The Dominion™ features speaker level
inputs designed to accept the output of an
amplified source, such as a stereo receiver's
speaker outputs. The use of this feature is
only recommended when no suitable line-
level signal is available.
HIGH LEVEL
When connecting a single Dominion™
INPUT PLUG
in mono to a two-channel receiver's speaker
CH. 1 CH. 2
(L) (R)
outputs, you will use both the Left and
Right connections on the "Speaker Level"
inputs plug of the Dominion™. Use good-
quality speaker cables (up to 12 AWG / 3
mm ) to make these connections. Make
2
sure you capture all the wire strands in
each connector port and do not allow any
of these wires to short together.
You can make the connections to
the Dominion™ subwoofer's inputs at the
receiver's output terminals, or at the main
speakers, whichever is more convenient. On
receivers with A/B speaker circuit selectors,
you can connect the Dominion™ to the "B"
outputs, giving you the ability to easily
switch the subwoofer's signal on and off
with the receiver's speaker circuit selector
switch.
The input section of your Dominion™
TO SATELLITE
SPEAKERS
will sum the left and right inputs to mono
and apply low-pass filtering to feed the
(R) (L)
subwoofer's internal amplifier when the "LP
Filter" of your Dominion™ is switched "on."
Because the main speakers are being
HIGH LEVEL
INPUT PLUG
fed in parallel with the inputs of the
Dominion™, they continue to operate as
CH. 1 CH. 2
(L) (R)
full-range speakers. Any adjustment of the
"LP frequency (Hz)" knob will only affect
the sound of the Dominion™, not the main
speakers.
WARNING
| d108 & d110