Advertisement
Operating your Fan
Fan control switch
The control switch positions are:
•
0 = OFF
•
I = Low Speed
Cleaning
To avoid risk of electric shock, before
cleaning, you MUST ALWAYS switch off
and unplug the Fan before cleaning.
Use only a soft, damp cloth to gently wipe
the Fan and dry well.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase. (Refer to back of booklet).
•
II = Medium Speed
•
III = High Speed
Goldair – New Zealand
Monday – Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
info@goldair.co.nz
Check that the Fan control switch is set to
the off position before plugging into the
mains supply.
Place the Fan on a dry, level and sturdy
surface.
Plug the power cord into the socket,
making sure the speed control is at OFF
position.
To operate the fan turn speed control dial
clockwise until desired wind speed is
achieved.
To activate the oscillation function, push
down the oscillation pin on the top of the
motor. The fan will then oscillate until the
pin is pulled back up.
DO NOT immerse the Fan in water and
never allow water to enter the motor
housing.
DO NOT use harsh chemicals to clean the
Fan.
SUPPORT AND TECHNICAL ADVICE
Goldair – Australia
Monday – Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
info@cdbgoldair.com.au
Advertisement
