Advertisement
Radio Frequency (RF) Protection Rearm Timer
Each time the system is disarmed using the transmitter the device will begin a protection mode
countdown. This is a timed secondary protection mode. If you do not start your vehicle within 60
seconds, your Silencer system will become rearmed and your engine will become disabled again.
Note: If your system operates from a "Automatic Disarm Transmitter", the 60 second RF protection
timer will not time-out and will rearm your system if you remain within 60 feet of your vehicle.
Automatic/Manual Disarm Transmitter Programming
If your transmitter package contains one or more of the 1-button automatic disarm transmitters, the
default operating mode will be "Manual Mode" (to preserve the battery life while not in use). To
change the operating mode to "Automatic Mode", follow these steps:
1. Press the middle area of the button and hold it down until the LED light on the side of the but-
ton becomes solid red. Release the button.
2. Press and release the center of the button 3 times. You will notice that the red LED light will be
off.
3. Press and hold the center of the button until the LED flashes. Release the button.
3 flashes = The transmitter is in "Automatic Disarm" mode.
1 flash = The transmitter is in "Manual Disarm" mode.
4. Confirm the mode of the transmitter. Press and release the center of the button and watch the
flash sequence of the LED.
5. The transmitter operating mode can be changed at any time by following steps 1-3. Confirm
the mode by following step 4.
3
Advertisement
